It is recommended to use an appropriate
mounting bracket specific for desired
mounting location (variety of mounting
brackets can be purchased at your local dealer)
and the rubber seal (seen in Fig. 2) for the
installation surface of the heater, when
installing the heater.
In case the heater is installed in a large
passenger van or a bus, it may be installed
without using mounting brackets.
In case the heater is installed onto a
pedestal or a mounting bracket, cover the air
intake, exhaust pipe, and the fuel pipe areas
with a metal cover.
Fig. 2b - Leave some free space
For heaters AUTOTERM AIR-2D and AIR-4D, holes in the body of the vehicle
should be made as shown in Fig.3. Heater can be installed using mounting plates shown on
Fig. 2. In this case studs provided with heater must be replaced with longer studs.
Fig. 3 – Mounting holes
AIR-2D; AIR-4D AIR-8D AIR-9D
To Next Page
Loading...
