3
5.Press «Hold/Tilt%» button for 2 sec to measure slope in
%. To make angle mea- surement in degrees, press and hold
«Hold/Tilt%» button for 2 sec.
6.The magnets at the bottom allows the instrument to be
attached onto iron ma- terial measurement object. Press
the «ZERO» button, reset the value to proceed relative
measurement.
7.Press and hold «ZERO» button for more than 2 sec to
switch on the backlight. To switch off the backlight, press and
hold «ZERO» button for more than 2 sec.
8.“ERR” appears on the display when the tool inclines more
than 45 degrees from the vertical position.
4.Application:
Control and measurement of slope of any surface. It is used
in wood processing industry (especially in furniture
manufacturing industry) for wood angle accurate cutting;
To Next Page
Loading...