6.
1. Place the scale on a flat, stable surface. Level the scale using the leveling bubble at the lower left
side of the display.
2. With the weighing platter empty, press the ON/OFF/ZERO key to power on the scale. The
self-check will run, show the version number “
”, display full capacity e.g. “F15.000kg”, the
scale will display a zero reading.
NOTE: The proper (power-on zero-point) range is: (calibration zero-point) ±20% FS
3. To power off the scale, press and hold ON/OFF/ZERO key.
OPERATIONS & SETTINGS
POWER ON / POWER OFF
NORMAL WEIGHING MODE
When scale is powered on and back to 0, place the weighing objects on the platform. The display will show
the weight and the units of weight currently in use.
SWITCHING UNIT OF MEASUREMENT
In normal weighing mode, press and hold TARE/UNIT key to switching the measuring units between lb, kg, g, oz, lb:oz.
1. You can press the ON/OFF/ZERO key at any time to set the zero point from which all other weighing
is measured. When the zero point is obtained, the display will show the indicator for zero.
2. ZERO key range is (power-on zero-point) ±5% FS. ZERO function is only activated when the scale
is in steady weighing mode and this also clear the recorded tare weight, the ZERO indicator will be
lighted on, NET indicator will be off. ZERO function will be not activated when the current weight is
not in the range of (power-on zero-point) ±5% FS, and it will display “
” or “
”, then
back to previous weight reading.
1. Zero the scale by pressing the ON/OFF/ZERO key if necessary when reading is stable. The zero
indicator will be on.
2. Place a container on the platform, a value for its weight will be displayed.
3. Press the TARE/UNIT key to tare the scale. The weight that was displayed is stored as the tare value
and that value is subtracted from the display, leaving zero on the display. The "NET" indicator will
be on. As product is added only the weight of the product will be shown. The scale could be tared a
second time if another type of product was to be added to the first one. Again only the weight that is
added after taring will be displayed.
4. When the container is removed a negative value will be shown. If the scale was tared just before
removing the container this value is the gross weight of the container plus all product that was
removed. The zero indicator will also be on because the platform is back to the same condition it was
when the ON/OFF/ZERO key was last pressed. Note: TARE range for this scale is up to 100%FS.
ZEROING THE DISPLAY
TARING
To Next Page
Loading...
