Weight signal is too large
No proper data can be displayed
Weight signal is too small
Zero point is over the setting range
Zero point is below the setting range
Error in unit key operation
The setting parameter(s) is not in normal range
There is an error in calibration
ADC is over max. range CAP. --------Capacity
Voltage
To set and store the indirect unit price
PLU address
Weighing unit selecting
Recall PLU
To unload the weight
To load the weight
To input load weight
Calibration enable switch is ON
Calibration enable switch is OFF
DISPLAY SYMBOL MEANINGS
18.
To Next Page
Loading...
