User Manual
8 www.AvantcoEquipment.com
Cleaning and Maintenance
Disassembling and Assembling the Tanks:
To disassemble and assemble the tanks or to change
the rubber tank gaskets :
1. Disconnect the unit by removing the plug.
2. Remove the cover from the tank.
3. Remove the mixing paddle from its shaft. For
the pump disassembling follow the instructions
reported on the diagram (Fig.6).
4. Lift container with both hands by a light,
swinging motion. If there is difficulty, please wet the
cooling column and gasket.
5. To remove tap, lift it from its setting.
6. Change the gaskets for tanks and taps only
with the genuine gaskets that are supplied by an
authorized supplier.
To reassemble the unit, repeat the above
operations in reverse.
Fig. 6
To Next Page
Loading...