indicator will go off when the set temperature is met.
Standby
• You can manually set your unit to the mode of “stand by” by pressing and holding both pads
(warmer) and (colder) for the lower zone for approximately 3 seconds, provided the pads are
unlocked and no any other setting operation is in process (Display does not flash). The
indicator will light to confirm this setting.
• Whenever the unit is switched on, all the display and indicators will light for 3 seconds with a
beep sound. Then the unit will automatically resume its previous setting when it was switched
off. If the unit was previously in “stand by” mode when switched off, it will resume the mode of
“stand by” and the indicator will light.
To Next Page
