Jumper Clamp Indicator Instruction
Input low
voltage
protection
14.0V±0.5V
17.5V±0.5V
When the power of the jump starter is too
low, after connecting the starter and the
car，the " " symbol is on, the buzzer
sounds once every 1 second, and the
current voltage of the starter power is
displayed.
Input high
voltage
protection
Short
circuit
protection
Support
Support
Reverse
connection
protection
Support
When the red/black clips of the wire clip is
reversely connected to the car battery
(battery voltage ≥0.8V), the " "symbol is on,
the " "symbol flashes, the buzzer sounds
once every 1 second.
Multi-frequency
protection
Work instruction
Support
Support
Standby
instruction
Car battery
voltage
detection
8 times
When working normally, display the voltage
of the current jump starter.
When the wire clip is only connected to the
car battery (the car battery voltage needs to
be ≥8V), the" " symbol is on, and the
current car battery voltage is displayed.
Item
Technical
parameters
Instruction
When the car voltage is too high, after
connecting the starter and the car,the "
" character flashes and the buzzer beeps for
a long time.
When the red and black clips are
short-circuited in the standby state,
the " "symbol is on, the " "symbol
flashes,the buzzer sounds once every 1
second.
When start up to 8 times continuously,the
" "symbol flashes.
The" " symbol circulate instructions
from left to right.
07
To Next Page
Loading...
