Method
A:
1. Press the wall-mount lever, and pull the IP Deskphone away from the stand,
as shown in Figure 11.
2. Use the stand cover (the part you removed in “Removing the stand cover”), to
mark the wall-mount holes by pressing the bottom of the stand cover firmly
against the wall in the location where you wish to install the IP Deskphone.
Four small pins on the bottom of the stand cover make marks on the wall.
3. Use the marks as a guideline for installing the wall-mount screws (not
provided). Install the screws so that they protrude 3 millimeters (mm) (1/8
inch) from the wall.
4. Install the IP Deskphone stand mounting holes over the screw heads as
indicated in Figure 10 (Method A). You need to remove the IP Deskphone
from the wall to adjust the lower screws.
5. When the lower screws are snug, install the IP Deskphone on the
mounting screws, and then tighten the top screws.
Figure
11:
Rotate the IP Deskphone into the
wall mount
po
siti
on.
To Next Page
Loading...
