While on an active call
205
Using the Call Park feature
You can use the Call Park feature to temporarily park a call so that you or
another user can retrieve the parked call from another phone. Using Call
Park does not tie up a line, because the call is held on the IP Office call
server.
A timer determines how long a call can remain parked; this timer is
configured by your system administrator. If the timer expires before the
call is retrieved at another extension, the call is returned to your phone.
To park a call:
1. Press the Feature soft key.
2. Press the CPark soft key.
The screen displays the message Call
Park?
3. Press the Yes soft key.
The deskphone displays the following
prompt: PrkOn:>
4. Using the key pad, enter an ID for the
parked call. Enter an ID that is up to 9
digits in length. You will need to enter
this ID when you retrieve the call from
park.
Note: If there is not currently an active
called parked that uses the ID that you
have entered, the deskphone displays
Forbidden.
To Next Page
Loading...
