Avaya 1230 - Introduction

Chapter 13: Device Settings on the
IP Deskphone with SIP
Software
Important:
An Avaya 1200 Series IP Deskphone with SIP Software displays different menus than an
IP Deskphone with UNIStim software.
Introduction
This chapter describes how to configure the Device Settings parameters on the IP Deskphone with
SIP Software. This includes items such as the IP address, the subnet mask, and the gateway IP
address of the IP Deskphone.
The Device Settings parameters are listed below in the order they appear on the Device Settings
menu of the IP Deskphone with SIP Software. Read the section at the end of this chapter that
explains how to provision the Device Settings parameters. If you are familiar with the Device
Settings parameters, skip the last section in the chapter and proceed to the provisioning
instructions.
• Enable 802.1x (EAP)
• Device ID
• Password
• Enable 802.1ab (LLDP)
• DHCP: Yes, No
• SET IP
• Net Mask
• Gateway
• DNS IP1
• DNS IP2
• Ntwk Port Speed: Auto, 10BT, 100BT
• Ntwk Port Duplex: Auto, Force Full, Force Half
• Disable Voice 802.1Q
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 145
Comments? infodev@avaya.com