• Voice VLAN: No VLAN, Manual
• VLAN Filter
• Ctrl Priority bits: Auto, 0–7
• Media Priority bits: Auto, 0–7
• Disable PC Port
• PC Port Speed: Auto, 10BT, 100BT
• PC Port Duplex: Auto, Force Full, Force Half
• Disable Data 802.1Q
• Data VLAN: No VLAN, Manual (value from 1 to 4094)
• Data Priority bits: Auto, 0–7
• PC-Port Untag al
• Cached IP
• Ignore GARP
• Provisioning: Server URL, Protocol (TFTP/FTP/HTTP), Device ID, Password
• PVQMon IP
• NAT Traversal: NAT Signal (None/ SIP Ping/ STUN), NAT Media (None/ STUN), NAT TTL,
STUN S1 IP, STUN S2 IP
• SSH: Yes, No
• SFTP: Yes, No
802.1x (EAP) Port-based network access control
Extensible Authentication Protocol (EAP) supports multiple authentication methods and represents a
technology framework that facilitates the adoption of Authentication, Authorization, and Accounting
(AAA) schemes, such as Remote Authentication Dial In User Service (RADIUS). RADIUS is defined
in RFC2865. The IP Deskphone with SIP Software supports only the MD5 authentication method.
802.1x defines the following three roles:
1. Supplicant—an IP Deskphone that requires access to the network to use network services.
2. Authenticator—the network entry point to which the supplicant physically connects (typically
a Layer 2/3 switch). The authenticator acts as the proxy between the supplicant and the
authentication server. The authenticator controls access to the network based on the
authentication status of the supplicant.
3. Authentication server—performs authentication of the supplicant.
Enable and disable Network-level authentication through the EAP configuration menu.
The RADIUS server is the authentication server and performs the actual authentication of the
supplicant. The following EAP methods are supported:
•
EAP-MDS on page 268
Device Settings on the IP Deskphone with SIP Software
146 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com
To Next Page
Loading...
