2. Yes: The IP Deskphone with SIP Software is configured to get a standard set of Device
Settings parameters from the DHCP server.
NO DHCP mode
No DHCP mode is also known as Manual Device Settings. In this mode, the IP Deskphone does not
need a DHCP server because no DHCP requests are sent during startup. All necessary parameters
must be configured manually or through the device configuration file.
The minimum following parameters must be configured to achieve normal operation:
• SET IP
• Net Mask
• Gateway
• DNS IP
• Provisioning server IP, protocol, and, if user authentication is required to access the
provisioning server, the user credentials
Note: TFTP protocol does not require user authentication. Device ID and password are
ignored. FTP protocol requires user authentication and the default Device ID is anonymous
with no password.
HTTP protocol can operate with or without user authentication. If no authentication is required,
make sure to clear the Device ID and password fields in the configuration dialogue.
SET IP
Select SET IP in the Device Settings menu to configure the IP address.
Net Mask
Enter a subnet mask In the Net Mask field.
Gateway
Enter an IP address of the local gateway in the Gateway field.
NO DHCP mode
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 153
Comments? infodev@avaya.com
To Next Page
Loading...
