EasyManua.ls Logo

Avaya 1230 - SRTP Support with Avaya Aura

Avaya 1230
428 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
SIP 4.4 includes a default device certificate in the firmware, allowing easy connection to Avaya Aura
through Session Manager using TLS . The IP Deskphones already have an embedded CA
certificate which is trusted by Avaya Aura
®
; the embedded device certificate eliminates the need for
customers to generate and install device certificates manually.
If used, embedded device certificate information is displayed in the IP Deskphone and in the output
of appropriate PDT commands.
The default embedded device certificates are trusted by the Avaya Aura
®
system. If Aura is
configured so that default certificates are replaced by customer certificates, then appropriate CA and
device certificates must be installed on the IP Deskphones.
Important:
The default embedded device certificates are trusted by the Avaya Aura
®
system. If Aura
®
is
configured so that the default certificates are replaced by customer certificates, then the
appropriate CA and device certificates must be installed on the IP Deskphones as well.
Configuration
To support the embedded device certificate, SIP 4.4 introduces the following parameter:
USE_DEFAULT_DEV_CERT [YES/NO]
— YES – Use the default device certificate if no customer device certificate is installed.
— NO – Do not use the default device certificate (default).
This parameter controls the use of the default device certificate for HTTPS/TLS connections. The
default value is NO. It is configured in the device configuration file.
SRTP support with Avaya Aura
®
SIP 4.4 introduces support for SRTP with Avaya Aura
®
.
Note:
To use SRTP, you first have to be using TLS. That is, you cannot have secure media without
using secure signalling.
The following SRTP modes are supported:
Secure Only
Best Effort Capability Negotiation
Configuration
SIP 4.4 introduces the following parameter to support SRTP on Avaya Aura
®
:
AVAYA_AURA_MODE_ENABLE [YES | NO]
The command specifies if Avaya Aura
®
-specific features are active on the IP Deskphone or not. The
default value is NO. It can be configured through the device configuration file and through server
profiles.
— YES – Avaya Aura-specific features are active.
Avaya Aura
®
-specific features
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 27
Comments? infodev@avaya.com

Table of Contents

Other manuals for Avaya 1230

Related product manuals