Avaya 1230 - Session Border Control Support

— NO – Avaya Aura-specific features are not active.
Important:
In the device configuration file, the parameter MKI must be set to NO.
Session Border Control support
Session Border Control (SBC) enables secure access for remote users.
SIP 4.4 supports the Avaya SBC for Enterprise 6.2 when the IP Deskphone is configured to use
TLS.
Other changes
Migration information
The following IP Deskphone migration information has been added to this document:
1. UNIStim IP Deskphone migration from CS 1000 to Avaya Aura
®
. See UNIStim IP
Deskphone migration from CS 1000 to Avaya Aura on page 393.
2. Migrating IP Deskphones with UNIStim firmware from CS 1000 to IP Office. See
Migrating IP
Deskphones with UNIStim firmware from CS 1000 to IP Office on page 402.
User provisioning
Information on IP Deskphone user provisioning using System Manager 6.3 FP2 has been added to
this document. See
User provisioning using System Manager 6.3 FP2 on page 408.
Adding the IP Deskphone to Avaya Aura
A Quickstart Guide — Add a 1200 Series IP Deskphone to Avaya Aura
®
has been added to this
document. See
Adding a new IP Deskphone to Avaya Aura
®
on page 413.
Configuring FACs and FNEs
Information on configuring FACs and FNEs on Avaya Aura
®
for the IP Deskphones has been added
to this document. See
Configuring FACs and FNEs for the IP Deskphones on page 416.
Creating speed dial lists
Information on creating a speed dial list on the IP Deskphone has been added to this document.
See
Creating a speed dial list on page 420.
Additional information
An appendix containing a listing of reference material and additional documentation has been added
to this document. See
Reference and additional documentation on page 423.
New in this release
28 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com