Avaya 1230 - Page 53

• FILENAME [filename] — specifies the file name to be downloaded for this section. For the
language and tone section, the use of multiple filenames is allowed.
Optional keywords in the provisioning file are:
• PROMPT [YES | NO] — used to indicate if the IP Deskphone should prompt the user for an
update before the operation is performed. This command is optional with the default configured
as NO.
- YES - enables the prompt
- NO - disables the prompt
• PROTOCOL [TFTP | FTP | HTTP] — defines the protocol used to download the file. The
IP Deskphone with SIP Software supports TFTP, FTP and HTTP protocols for file download.
This command is optional. If it is not present, the default protocol TFTP is used.
Important:
When using the TFTP protocol to transfer the software image, the average round trip time
must be < 75 ms. The IP Deskphone times out and aborts the software download if the
total download time is less than 10 minutes.
If the average round trip time is less than 75 ms, use the FTP or HTTP protocol to transfer
the software image.
If using FTP or HTTP, then SRV_USER_NAME and SRV_USER_PASS are also key words.
These commands specify the credentials used to log on to the file server for file download. If
not present, the protocol default credentials are used (no credentials for TFTP and HTTP and
anonymous with no password for FTP).
• SERVER_IP [address] — allows the IP Deskphone to connect to the specified IP address or
name of the server for which the file can be downloaded. If the address is not specified, the
SERVER_IP that is used is the same SERVER_IP that is used to download the provisioning
file.
• DELETE_FILES [YES | NO] — if present, erases the language and tone files stored in the
IP Deskphone before new files are downloaded. Otherwise, new files with different names are
added without erasing existing files. This command is optional. Note that there is a hard limit of
5 language files and 5 tone files that can be stored in the IP Deskphone. When the limits are
exceeded, no new file can be accepted for download.
- YES - erases the existing language and tone files
- NO - does not erase existing language and tone files
• SRV_USER_NAME [username] — If the protocol is FTP or HTTP, this keyword specifies the
user name to log on to the server.
• SRV_USER_PASS [password] — If the protocol is FTP or HTTP, this keyword specifies the
password to log on to the server.
The downloading of these files is initiated when an IP Deskphone is powered on, when an automatic
check for updates is invoked, or when you select Srvcs > Check for Updates. Any of these actions
causes the IP Deskphone to contact the provisioning server and attempt to read the provisioning
file. A Soft Reset (Srvcs > Reset Phone) does not cause the IP Deskphone to retrieve the
provisioning file.
Create the SIP provisioning files
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 53
Comments? infodev@avaya.com