Avaya 1230 - Device Configuration File Command Syntax

Device configuration file command syntax
Important:
The device configuration file uses the following syntax:
• [ ] – mandatory field
• < > – optional field
For example:
AUDIO_CODEC [ ] [ ] < >
would be filled in as
AUDIO_CODEC1 G729 G.729 codec
Caution:
The syntax of the commands in the device configuration file is case-sensitive. Verify that the
commands follow the case defined in this document.
Important:
Parameters in the device configuration file with empty values are not allowed and cause write
failure.
Server and network configuration commands
• SIP_DOMAIN[x] [domain_name] — preconfigures the proxy domain name for all servers. The
same configuration can be done through the domain configuration menu on the IP Deskphone.
- x - the number of the SIP domain number from 1 to 5.
- domain_name - the proxy domain name for all servers.
Note:
SIP_DOMAIN[x] is provisioned after user logout.
• SERVER_IP[x]_[y]_[ip_address] — configures the primary and secondary IP address for
each domain, two proxies for each domain.
- x - the domain number from 1 to 5.
- y - y – indicates whether it is the primary or secondary IP address. .
y=1 indicates the primary address and y=2 indicates the secondary address.
- ip_address - the IP address of the SIP proxy server.
• SERVER_PORT[x]_[y] [port_number] — configures the signaling ports for each proxy.
- x - the domain number.
- y - y – indicates whether it is the primary or secondary IP address.
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 61
Comments? infodev@avaya.com