Avaya 1230 - Feature Configuration Commands

Deskphone begins sending Discovery frames in non-VLAN mode. If the IP Deskphone still
does not receive an Offer then, after a pre-defined number of Discovery attempts, the IP
Deskphone reverts to VLAN tag mode again.
The default is NO.
• SRTP_ENABLED [YES | NO] — This parameter configures SFTP configuration values. The
default value is NO.
- YES – enables SRTP.
- NO – disables SRTP (default).
• HASH_ALGORITHM [SHA1 | MD5] — This parameter provides the hash algorithm. The
default value is SHA1.
- SHA1 – algorithm is Secure HASH Algorithm 1
- MD5 – algorithm is Message-Digest algorithm 5
• SSHPWD — This parameter configures SSH and SFTP passwords. The maximum limit is 49
characters.
• KEEPALIVE_RETRIES [x] — This parameter specifies the number of times that the IP
Deskphone attempts to connect to the proxy server. When the IP Deskphone determines that
the proxy server does not respond (keep-alive mechanism fails), it tries to re-establish the
connection the specified number of times.
Each reconnection attempt consists of several messages:
- TCP SYN messages if the connection is TCP or TLS
- SIP PING messages if the connection is UDP
The IP Deskphone logs out or registers to the secondary server if the primary proxy server
does not respond during the specified number of reconnection attempts.
The default value is 3.
- minimum value is 1
- maximum value is 10
• REGISTER_RETRY_MAXTIME [seconds] — This parameter configures in seconds the
maximum length of time that the IP Deskphone waits before it attempts to re-register with the
proxy server. The default value is 1800 (seconds).
- minimum value – 600 (seconds)
- maximum value – 1800 (seconds) (default)
Feature configuration commands
• TOVM_SOFTKEY_ENABLE [YES | NO]
- YES - enables the toVM soft key on the IP Deskphone.
- NO - disables the toVM soft key on the IP Deskphone.
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 65
Comments? infodev@avaya.com