Avaya 1230 - Page 66

• TOVM_VOICEMAIL_ALIAS <string> — customizes the user ID of the SIP URI of the voice
mail system. The default is transfertovm.
• TOVM_VOICEMAIL_PARAM<string> — customizes the parameter name of the SIP URI of
the voice mail system. The default is mbid.
• SCA_APPEARANCES — configures the maximum number of appearances used for outgoing
calls by the Shared Call Appearance (SCA) group. The valid range for this parameter is 2 to
24. The default value is 12.
• SCA_HOLD_BEHAVIOR [PRIVATE | PUBLIC] — configures the default behavior of the hold
button when user-determined behavior does not exist. When a user creates a new profile, the
default behavior is taken from this setting. After the creation of a new profile, this configuration
setting is not used. The default option is PUBLIC.
• SCA_LINE_SEIZE_EXPIRES [timeout] — This parameter allows the administrator to specify
expiration time in seconds for line-seize subscriptions (Single Call Appearance).
Allowed values are from 10 to 30 seconds. The default value is 15 seconds.
— timeout - expiration time for line-seize subscriptions in seconds.
• RTP_MIN_PORT
The minimum RTP port value is an integer between 2048 and 65535, exclusive of the restricted
SIP ports between 5059 and 5080. The default value is 16384.
• RTP_MAX_PORT
The maximum RTP port value is an integer between 2048 and 65535, exclusive of the
restricted SIP ports between 5059 and 5080. The default value is 32764..
Note:
The RTP port configuration parameters must satisfy the constraints that (RTP_MAX_PORT
- RTP_MIN_PORT) is greater than or equal to 10 and less than 1000.
Note:
If there is a provisioning error, RTP_MIN_PORT is reset to the default value of 16384 and
RTP_MAX_PORT is reset to the default value of 32764. An error message is logged. The
SystemConfig file stores 16384 and 32764, rather than the erroneous configuration values,
to indicate that the configuration attempt has been rejected.
• CALL_WAITING [SPEAKER | STREAM]
- SPEAKER - the call waiting tone is played on the IP Deskphone speaker. This is the default
option.
- STREAM - the call waiting tone is injected into the stream played on the transducer in use
for the active call
• DISTINCTIVE_RINGING [YES | NO]
- YES - turns on the distinctive ringing feature. This is the default option.
- NO - turns off the distinctive ringing feature.
Creating the provisioning files
66 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com