Avaya 1230 - Page 67

• USE_RPORT [YES | NO]
- YES - allows the IP Deskphone to work from behind and/or in front of a symmetrical NAT
with servers and/or clients that support RFC3581.
- NO - disables implementation of support for RFC3581. This is the default option.
Note:
To provision USE_RPORT, the IP Deskphone must be rebooted after the device
configuration file is updated.
• EXP_MODULE_ENABLE [YES | NO]
- YES - the IP Deskphone detects and enables an Expansion Module.
- NO - the IP Deskphone does not detect an Expansion Module. This is the default option.
• MAX_RING_TIME [x] — an integer between 30 and 600 that configures the number of
seconds for incoming calls to ring before ignoring them. 0 is a special value which disables this
feature. The default value is 0.
• ENABLE_UPDATE [YES | NO]
- YES - enables UPDATE message support and adds “UPDATE” to ALLOW header. This is
the default option.
- NO - disables UPDATE message support.
Note:
ENABLE_UPDATE is provisioned after user logoff.
• PROMPT_ON_LOCATION_OTHER [YES | NO]
- YES - prompt the user to select new location if location “other” was previously selected.
- NO - do not prompt the user to select new location if location “other” was previously
selected. This is the default option.
• VMAIL [vmail_number] — is the voice mail address, which can be the URI or the DN number
of the voice mail server. This command takes a string as a parameter. This is the default link
for a new user profile only. Individual users can customize the link through Prefs > User
Options > Voice Mail Settings. This command has no effect on the user profiles after it is
created.
- vmail_number - the number or URI of the voicemail server.
• VMAIL_DELAY [x] — is a delay, configured in milliseconds, between when the voice mail
server answers the call and the start of dialing the voice mail user ID. The default value is
1000ms.
- x - the delay in milliseconds
• LLDP_WAITING_TIME [timeout_sec] — This parameter allows the administrator to configure
the timeout in seconds the IP Deskphone should wait for the LLDP response.
The allowed values of the parameter are from 30 to 300 seconds. The default value is 30
seconds.
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 67
Comments? infodev@avaya.com