Avaya 1230 - Page 83

files with the file manager interface (this applies to WAV files on the IP Deskphone). The values
are YES and NO. The default value is YES.
- YES — allows the user to delete or copy WAV files on the IP Deskphone through the file
manager
- NO — does not allow the user to delete of copy WAV files on the IP Deskphone through the
file manager
• FM_IMAGES_ENABLE [Y | N] — allows the user to act on JPG and PNG files using the file
manager. The values are Y and N. The default value is Y.
• FM_CERTS_ENABLE [Y | N] — allows the user to act on CER and PEM files using the file
manager. The values are Y and N. The default value is N.
• FM_CONFIG_ENABLE [Y | N] — allows the user to act on CFG files using the file manager.
The values are Y and N. The default value is N.
• FM_LOGS_ENABLE [Y | N] — allows the user to act on CFG files using the file manager. The
values are Y and N. The default value is Y.
• HOTLINE_ENABLE [Y | N] — indicates if Hotline Service is enabled or disabled. The values
are Yes and No. The default value is No.
• HOTLINE_URL — used as the To field of INVITE message by the SIP IP Deskphone to notify
the Proxy Server that this is a call from a Hotline Deskphone. The HOTLINE_URL is not a real
URL of the Hotline target. The IP Deskphone has no idea about the Hotline target. The Proxy
server replaces the To field of INVITE request message with a real Hotline target when it
receives an INVITE request from the Hotline Phone. The default value is Hotline.
• SESSION_TIMER_ENABLE [YES | NO] indicates if the session timer service is enabled or
disabled. The values are Yes and No. The default value is Yes.
- YES — the Session Timer Service for the IP Deskphone is enabled, and the behavior of the
IP Deskphone complies with RFC4028.
- NO — the Session Timer Service is disabled.
• SESSION_TIMER_DEFAULT_SE — indicates the default session expiration in seconds. The
Session-Expires header, in a request, informs the terminating endpoint and proxies of the
Session-Expires interval value that the originating endpoint requires for the session timer
duration, in units of delta seconds. The default value is 1800.
• SESSION_TIMER_MIN_SE — indicates the minimum session expiration in seconds. The
default value is 1800.
• SET_REQ_REFRESHER [0 | 1| 2] — indicates what refresher value is configured in the initial
session request. The values are 0, 1, and 2. The default value is 0.
- 0 — indicates that the refresher is omitted
- 1 — indicates that the refresher is configured to UAC
- 2 — indicates that the refresher is configured to UAS
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 83
Comments? infodev@avaya.com