Avaya 1230 - Page 84

• SET_RESP_REFRESHER [0 | 1 | 2] — indicates what refresher value is configured in the 200
OK response. The values are 0, 1, and 2. The default value is 2.
- 0 — indicates that the refresher is omitted (only valid when SET_REQ_REFRESHER is not
equal to 0)
- 1 — indicates that the refresher is configured to UAS
- 2 — indicates that the refresher is configured to UAC
• ENABLE_INTERWORKING — used to enable the interworking feature to pre-authorize users
or groups of users to access automatic call answer. The configuration values are YES and NO.
The default value is NO.
- YES — the interworking feature is enabled.
- NO — the interworking feature is disabled.
• PORT_MIRROR_ENABLE [YES | NO] — used to enable or disable the Port Mirroring feature.
The values are YES and NO. The default value is NO.
- YES — The Port Mirroring prompt in the Advanced Diag Tools dialog is enabled and can be
modified.
Note:
If enabled, the Port Mirroring setting survives a reboot of the IP Deskhone, but not a
power off. If the IP Deskphone is powered off, Port Mirroring becomes disabled.
- NO — The Port Mirroring prompt in the Advanced Diag Tools dialog is permanently disabled
(dimmed) and cannot be modified.
• MEMCHECK_PERIOD <nnnnn> — used to determine the time period in seconds when the
Memory monitor wakes up (after re-start or the last memory check attempt). The values are
1800 (0.5 hrs) to 86400 (24 hrs). The default value is 86400 (24 hrs).
• DOS_PACKET_RATE — determines the maximum number of packets per second that is
allowed.
• DOS_MAX_LIMIT — specifies how many packets past the DOS_PACKET_RATE the IP
Deskphone can receive before packets are dropped. If packets are received at a rate of
DOS_PACKET_RATE +1, then packets are dropped after the time specified in
DOS_MAX_LIMIT (in seconds).
• DOS_LOCK_TIME — specifies the amount of time (in seconds) that the IP Deskphone stops
processing packets after DOS_MAX_LIMIT is reached. If DOS_PACKET_RATE is < 1, other
values are ignored and packets are not dropped.
• LOGSIP_ENABLE [YES | NO] — used to enable or disable SIP-logging. The values are YES
and NO. The default value is NO.
- YES — the SIP-logging Manager is active and starts to log SIP incoming and outgoing
packages into the log file in FFS.
- NO — the SIP-logging Manager is not active and cannot log SIP incoming and outgoing
packages into the log file in FFS.
Creating the provisioning files
84 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com