Avaya 1230 - Tone Configuration Commands

private Differentiated Services Code Point (DSCP) values to give better treatment to the traffic
coming from peer Avaya devices.
- YES - the IP Deskphone uses private DSCP values, unless overridden.
- NO - the IP Deskphone uses either one of the configured DSCP values or the system default
values.
• DSCP_CONTROL [x] — a value entered in decimal format between -1 and 63. If the value is
-1, the DSCP value is picked up by the Service Package. The default value is 40.
- x - a value from -1 to 63 indicating the DSCP value.
• 802.1P_CONTROL [x] — a value entered in decimal format between -1 and 7 representing the
802.1P value in the SIP signaling packets. If the value is -1, the 802.1P value is retrieved from
the Service Package. The default value is 6.
- x - the value from -1 to 7 indicating the 802.1P value.
• DSCP_MEDIA [x] — a value entered in decimal format between -1 and 63 representing the
DSCP value in the Real-time Transfer Protocol packets. If the value is -1, the DSCP value is
retrieved from the Service Package. The default value is 44.
- x - a value from -1 to 63 indicating the DSCP value.
• 802.1P_MEDIA [x] — a value entered in decimal format between -1 and 7 representing the
802.1P value in the IP Deskphone Media (RTP) packets. If the value is -1, then the 802.1P
value is retrieved from the Service Package is the 802.1 setting for media Real-time Transport
Protocol (RTP). The default value is -1.
- x - a value from -1 to 7 indicating the 802.1P value.
• DSCP_DATA [x] — a value entered in decimal format between -1 and 63 representing the
DSCP value in the provisioning packets. If the value is -1, the DSCP value is retrieved from the
Service Package. The default value is 40.
- x - a value from -1 to 63 indicating the DSCP value.
• 802.1P_DATA [x] — a value entered in decimal format between -1 and 7 representing the
802.1P value in the provisioning packets. If the value is -1, the 802.1P value is retrieved from
the Service Package. The default value is 6.
- x - a value from -1 to 7 indicating the 802.1P value.
Tone configuration commands
• DIAL_TONE [frequency1 | frequency2 | on_time | off_time] — used to select the tone
advising the caller that the exchange is ready to receive call information and invites the user to
start sending call information. You can select the country-specific tone. The default tone is the
North American tone.
- frequency1 - the frequency of tone 1.
- frequency2 - the frequency of tone 2.
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 89
Comments? infodev@avaya.com