VQMon configuration commands
It is important to read
How VQMon works on page 143 before configuring the VQMON parameters.
• VQMON_PUBLISH [YES | NO] — the command that is used to enable or disable the publish
message containing the voice quality monitoring metrics sent to the Proactive Voice Quality
Monitoring (PVQMoN) collecting server.
- YES - enables VQMoN.
- NO - disables VQMoN. NO is the default.
• VQMON_PUBLISH_IP [xxx.xxx.xxx.xxx] — used to configure the IP address of the PVQMoN
server that collects voice quality monitoring metrics from the publish message.
This IP address is used only within the report.
• LISTENING_R_ENABLE [YES | NO] — used to enable or disable the alerts based on the
Listening R Minor and Major Thresholds. The default value is vocoder-dependent, using a
scale from 1 (lowest quality) to 100 (highest quality). Currently, default values are used based
on VOCODER on a per-call basis, as summarized below.
- YES - enables the sending of the alert report based on the Listening R Value.
- NO - disables the sending of the alert report based on the Listening R Value.
VOCODER_G711_ULAW
VOCODER_G711_ULAWPLP
LISTENING_R_WARN = 80
LISTENING_R_EXCE = 70
VOCODER_G723
VOCODER_FLAG_G723_RATE_53
VOCODER_FLAG_G723_RATE_63
LISTENING_R_WARN = 60
LISTENING_R_EXCE = 50
VOCODER_G729
VOCODER_PCM8
vqmonVocoderTypeUnknown
LISTENING_R_WARN = 70 (default if not
configured and unknown type)
LISTENING_R_EXCE = 60
• LISTENING_R_WARN [xx] — the threshold to send a report on Listening R less than [xx]. The
default value is 70. Using a value of 0 resets it to the default value, based on the far-end
VOCODER.
- xx - is an INTEGER value used as the threshold.
• LISTENING_R_EXCE [xx] — the threshold to send a report on Listening R less than [xx]. The
default value is 60. Using a value of 0 resets it to the default value, based on the far-end
VOCODER.
- xx - is an INTEGER value used as the threshold.
• PACKET_LOSS_ENABLE [YES | NO] — used to enable or disable the alerts based on the
packet loss thresholds. Packet loss is the fraction of RTP data packets from the source lost
Creating the provisioning files
92 SIP Software for Avaya 1200 Series IP Deskphones-Administration March 2015
Comments? infodev@avaya.com
To Next Page
Loading...
