Avaya 1230 - User Login Commands

• LOG_LEVEL [x] — This parameter defines which IP Deskphone bugs are logged in the ECR
file. The following values are used for configuring the logging level on the IP Deskphone.
x - level of bugs from 0 to 255. The default value is 2.
- 0 - logging is blocked
- 1 - log only Critical bugs
- 2 - log Critical / Major bugs
- 3 - log Critical / Major / Minor bugs
- if >= 4 – log all information and bugs
Important:
LOG_LEVEL 4 is intended for debug purposes only. Do not set LOG_LEVEL to 4 or a higher
value unless you are instructed to do so by Avaya support.
User login commands
• AUTOLOGIN_ID_KEY[nn] [* | xx] [userID@domain name] — This parameter is located
within the IP Deskphone-specific configuration file. This is the ID that the IP Deskphone uses to
register and authenticate. The default User ID "user1" is used if an ID is not supplied and the
IP Deskphone is not logged in.
- * - indicates that the IP Deskphone should use its MAC address (lower case) as the User ID
- xx - an ASCII string that corresponds to the User ID.
- userID@domain name – the user ID must be followed by the domain name; for example,
jsmith@company_name.com; 2247@company_name.com
Note:
To provision AUTOLOGIN_ID_KEY[nn] [userID@domain name], the IP Deskphone must
be rebooted after the IP Deskphone configuration file is updated. To force a hard reboot
after the IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in
the device configuration file.
• AUTOLOGIN_PASSWD_KEY[nn] [xx] — This parameter is located within the IP Deskphone-
specific configuration file. There is no default password. If this parameter is blank and
AUTOLOGIN_ENABLE is configured to USE_AUTOLOGIN_ID (or 2) in the device
configuration file, the IP Deskphone does not log on.
Note:
To provision AUTOLOGIN_PASSWD_KEY[nn] [xx], the IP Deskphone must be rebooted
after the IP Deskphone configuration file is updated. To force a hard reboot after the
IP Deskphone configuration file is updated, configure FORCE_REBOOT YES in the device
configuration file.
• PROMPT_AUTHNAME_ENABLE [YES | NO] — This parameter causes the user to be
prompted to enter an authentication name when they log on to the IP Deskphone. For a CS
Create the device configuration file
March 2015 SIP Software for Avaya 1200 Series IP Deskphones-Administration 95
Comments? infodev@avaya.com