Avaya 1408 - Bridged Appearance Buttons

1408/1416 Phone User Guide Page 25
15-601040 Issue 07i (06 November 2015)IP Office 9.0
Comments on this document? infodev@avaya.com
Introduction: Appearance Buttons/Menu
1.11.3 Bridged Appearance Buttons
A bridged appearance button shows the state of one of another user's call appearance buttons. It can be used to answer
or join calls on that other user's call appearance button. It can also be used to make a call that the call appearance user
can then join or retrieve from hold.
· When the user's call appearance button alerts, your matching bridged appearance button also alerts. The bridged
appearance button can be used to answer the call on the call appearance button user's behalf.
· When the call appearance button user answers or makes a call using that call appearance, your matching bridged
appearance button show the status of that call, for example connected, on hold, etc. The bridged appearance
button can be used to retrieve the call if on hold or to join the call if active.
· Bridged appearance buttons are not supported between users on different systems in a Small Community Network
.
If you have any bridged appearance and or call coverage buttons, you can set the type of ringing (coverage ring) that
should be used when a call alerts on any of those buttons. The options are to use normal ringing, a single non-repeated
ring (abbreviated ring) or no ring. The coverage ring setting is only used if you do not already have a connected call. If
you already have a connected call in progress, the shorter of your coverage ring and the system administrator set
attention ring settings is used.
Bridged Appearance Button Lamps
The following lamp states are used by appearance buttons configured to be bridged appearance buttons.
Button Lamps
Bridge Appearance Button State
Red off.
Green off.
Idle
The bridged appearance is not in use.
Red off.
Green slow flash.
Alerting
The matching call appearance is alerting for an incoming call. This is accompanied by ringing.
If the user is already on a call, only a single ring is given.
Red on.
Green slow flash.
Alerting + Selected
As above but Ringing Line Preference has made this the user's current selected button.
Red off.
Green on.
In Use Elsewhere
The matching call appearance button is in use.
Red on.
Green on.
In Use Here
The user has made a call or answered a call on the bridged appearance, or bridged into it.
Red off.
Green fast flash.
On Hold Here
The call has been put on hold by this user.
Red off.
Green flash.
On Hold Elsewhere
The call on that call appearance has been put on hold by another user.
Red off.
Green broken
flash.
Inaccessible
The button pressed is not useable. The call is still dialing, ringing or cannot be bridged into.
189
140