Avaya 1600 Series - Page 29

Static Addressing Installation
Issue 1 April 2007 29
5. Enter the IP netmask followed by the # button.
The telephone displays:
where nnn.nnn.nnn.nnn is the current system value of the HTTP/HTTPS server IP
address.
6. Enter the HTTP Server IP address followed by the # button.
The telephone displays one of the following texts, depending on the current setting of the
system parameter NVL2Q (802.1Q):
7. Press * to change 802.1Q to the next sequential value. For example, if the current value is 0
(auto) pressing * changes it to 1 (off) and if the current value is 2 (on), pressing * changes it
to 0 (auto).
The display is updated to show the current status of 802.1Q.
8. Press the # button to continue the procedure without changing the displayed status of
802.1Q
The telephone displays the following text:
where dddd is the current system value of the 802.1 VLAN ID.
9. Enter a valid value between 0 and 4094 for the new value of the 802.1 VLAN ID.
The telephone displays the following message:
where ddd is the current system value of the DHCPOFFER wait period.
FileSv=nnn.nnn.nnn.nnn
New=_
If NVL2Q is 0: 802.1Q=auto
*=change #=OK
If NVL2Q is 1: 802.1Q=off
*=change #=OK
If NVL2Q is 2: 802.1Q=on
*=change #=OK
VLAN ID=dddd
New=_
VLAN test=ddd
New=_