H323 Telephone Installation Page 68
Issue 23e (Friday, February 15, 2019)IP Office™ Platform 11.0
Comments on this document? infodev@avaya.com
3.2 Secondary Ethernet (Hub)/IR Interface Enable/Disable
Use the following procedure to enable or disable the hub interface found on many Avaya IP phones which can be used for
user PC connection . The hub interface is set to enabled by default.
1600 Series Phones
1. While the phone is on-hook and idle, press the following sequence: MUTE <password> 468 # (MUTE
<password> INT #). The phones port settings are shown in sequence. The options vary between different
models of phone.
·
PHY2=
This is the PC connection LAN socket marked as on the phone. Press 1 or 0 to enable or disable the hub
interface respectively. To continue, press #.
·
IR=
This is the infrared (IR) port located on the front of some H.323 IP phones. Press 1 or 0 to enable or disable
the hub interface respectively. To continue, press #.
2. If you changed the setting, Save new values? is displayed. To end the procedure or save the new values, press
#. If you press #, New values being saved is displayed and then the set returns to normal operation.
9600 Series Phones
1. While the phone is on-hook and idle, press the following sequence: MUTE <password> #.
2.Scroll the menu to INT.
3.Select the port that you want to adjust. The options are Ethernet and PC Ethernet.
4.Use the < and > buttons to scroll through the port's possible settings. The additional option Disabled is available
for the PC Ethernet port.
5. Press Save.
6. Select another procedure or press Exit to restart the phone.
15
67
67
67
To Next Page
Loading...
