Local Administrative Options Using the Telephone Dialpad
Issue 5 April 2010 85
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons.
The following text displays left-justified at the top of the display:
2. If you do not want to clear all values, press * (no) to terminate the procedure and retain the
current values.
A screen displays the following prompt on the top line:
3. Press the * button to terminate the procedure without clearing the values. Press the # button
to clear all values to their initial default values.
A confirmation tone sounds and the following text displays left-justified at the top of the
display:
The telephone is cleared to its “out of the box” state.
Disable/Enable Debug Mode
Use the following procedure to turn the debug mode for the button module serial port on or off.
1. While the telephone is on-hook and idle, press the following sequence of keys on the
faceplate of the telephone:
Mute 3 3 2 8 4 # (Mute D E B U G #)
Note:
Note: Press the Mute button momentarily. Do not press this button while pressing other
keys/buttons.
Clear all values?
*=no #=yes
Are you sure?
*=no #=yes
Clearing values.
To Next Page
Loading...
