Avaya 3616 - IP Office AVPP Setup

2. AVPP Installation and Configuration
3600 Series IP Phone Installation Page 23
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
2.4 IP Office AVPP Setup
This process is used to add the network location of the AVPP unit to the IP Office configuration.
1. Start IP Office Manager and receive the configuration from the IP Office control unit.
2. Click on
System.
3. Select the System tab.
4. Set the AVPP IP Address to match the static IP address of the AVPP unit.
5. If the IP Office is being used for DHCP support of the 3600 Series phones, set the TFTP Server
IP Address to match the IP address of the TFTP server from which the 3600 Series handsets
should get their software.
• If otherwise, the location of the TFTP server for the 3600 Series phones should be set
through the DHCP server or through the configuration of the handsets if using static IP
configuration.
6. Click OK.
7. Click
or select File | Save Configuration. to send the updated configuration back to the IP
Office control unit. Click OK.