3600 Series Wireless IP Phone Installation
3600 Series IP Phone Installation Page 26
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
SVP-II Configuration
The SVP-II Configuration screen allows you to set the mode of the AVPP for an IP environment. It is
also where you can lock the AVPP for maintenance and reset the AVPP after maintenance.
If the IP address is changed, the AVPP will automatically lock for maintenance and the AVPP must be
reset upon exit. All active calls are terminated during a reset.
1. From the main menu, scroll to SVP-II Configuration and press Enter.
• SVP-II Mode
Defaults to NetLink IP for an IP environment. Press enter to select and the screen is immediately
redrawn with additional options for the IP environment.
• Phones per Access Point
Enter the number of simultaneous calls supported for your type. Access point specifications are
detailed in the configuration notes for each brand and type.
• 802.11 Rate
Select 1MB/2MB to limit the transmission rate between the wireless phones and access points.
To allow the wireless phone to determine its rate (up to 11Mb/s), select Automatic.
To Next Page
Loading...
