4. Certifying the Installation
3600 Series IP Phone Installation Page 57
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
In the Detl (detail) mode the display would appear as follows. The Left/Right arrow keys will move
between access points.
i : b b b b b b s n c h b c n
e e e e e e e e e e e D G H I
r r r r r r r r r r r r r + x x x x
m m m G : g g g g P : p p p p
Any Smry
Where:
i
Index of selected AP (value will be from 0 to 3 inclusive).
bbbbbb
The last three octets of the BSSID for a discovered access point.
sn
Signal strength in –dBm.
ch
Channel.
bcn
Beacon interval.
eeeeeeeeeee
SSID (the first 11 characters).
DGHI
Standards supported.
rrrrrrrr
Rates supported. Basic rates will have a “b” following the rate.
+
more rates are supported than those displayed.
xxxx
WMM or UPSD if those QoS methods are supported.
mmm
Security mode.
G:gggg
Group key security.
P:pppp
Pairwise key security.
Any/MyID
Softkey to toggle between “single SSID” and “any SSID” modes.
Detl/Smry
Softkey to toggle between the multiple AP display (summary), and the single AP
display (detail).
To Next Page
Loading...
