Avaya 3641 - Using the Admin Tabs; Connecting the Handset

Part C: Handset Administration Tool
108 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool
2. Using the Admin Tabs
Launch the Handset Admin program from the Start menu.
The Handset Administration Tool has two separate functional areas: the Admin Tabs and
the Handset Settings Editor.
The Admin Tabs are used to connect to the handset, set and change the password,
retrieve error messages, update handset software, and update the Handset Administration
Tool software.
The Handset Settings Editor is used to configure handsets, as well as create, save and
copy Admin menu options. See Chapter 3 The Settings Editor for detailed instructions on
using the Handset Settings Editor.
The Handset Administration Tool uses indicators to alert you to the status of the action
being performed.
• Green – indicates ready status.
• Yellow – indicates caution or attention.
• Red – indicates an error
• Gray – indicates not active status.
• Blinking – indicates entry is needed or waiting on system response.

If closed, the Admin Tabs may be opened from the Settings Editor by selecting the
Admin or View option on the Settings Editor menu bar.
2.1 Connecting the Handset
There are six tab labels that describe each of the available functions. The tab labels are:
Connect, Password, Error info, Firmware, Settings, and Version.
The Connect tab has a prompt line which will state one of three messages: Power handset
off, then put it in the Dual Charger; Enter handset’s password; or Connected.