Avaya 3641 - Avaya Aura Communication Manager Configuration; Configuring a Standalone Station; Configuring an Associated Station

Part B: Avaya 3641/3645 Wireless IP Telephone
48 Avaya Voice Priority Processor, Avaya 3641/3645 Wireless IP Telephone, Handset Administration Tool
3. Avaya Aura™ Communication Manager Configuration
You can configure the Avaya 3641/3645 Wireless IP Telephone as a stand-alone station or
associate it with a desk station. When the Avaya 3641/3645 Wireless IP Telephone is
associated with a desk station, the user can make and handle calls from either the Avaya
3641/3645 Wireless IP Telephone or the desk station.
3.1 Configuring a Standalone Station
To configure an Avaya 3641/3645 Wireless IP Telephone as a stand-alone station, you
must add a station on the Avaya Aura™ Communication Manager for the Avaya
3641/3645 Wireless IP Telephone.
To administer a stand-alone station on the Avaya Aura™ Communication Manager for a
Wireless IP Telephone:
1. From the Avaya Aura™ Communication Manager administration software, add a new
station.
2. Set “Type” to “4612.” *
3. Administer a station security code.
4. Complete the remainder of the station form as you would for a desk station.
5. Repeat Steps 1 through 5 for each stand-alone Wireless IP Telephone.
* If the phones will be registered to an ACM with version 5.2.1 or higher, then the station
type “
4612CL” must be used instead of “4612”, in order to have a fully functional
Answered Call Log and Missed Call Log.
On any older ACM version station type “4612” is used, as usual.
3.2 Configuring an Associated Station
To configure an Avaya 3641/3645 Wireless IP Telephone as an associated station, you
must add a station on the Avaya Aura™ Communication Manager for the Avaya
3641/3645 Wireless IP Telephone and then associate that station with a desk station.
To administer an associated station on the Avaya Aura™ Communication Manager for a
Wireless IP Telephone:
1. From the Avaya Aura™ Communication Manager administration software, add a new
station.
2. Set “Type” to “4612.”
3. Set “Security Code” to the same security code used for the extension to which this
Wireless IP Telephone will be associated (that is, the desk station). You can use a
different security code, but to make it easier for the user it is recommended that you
use the same security code as the desk station.
4. Set “Message Lamp Ext” to the extension of the associated desk station.
5. Set “Bridged Call Alerting” to “y.”
6. Set “Auto Select Any Idle Appearance” to “y.”