License Management
Issue 6, January 2011 77
5.2 Minimum Configuration Process
Follow these steps to configure the Wireless IP Telephone.
1. Contact your service representative for information about downloading the latest Avaya
3641/3645 Wireless IP Telephone – IP software.
Load the latest version of the Avaya 3641/3645 Wireless IP Telephone code and
place it on the TFTP Server and ensure the TFTP Server is started. The following files
must have the filenames shown and are downloaded in this order:
Description Filename
Configuration file
13
slnk_cfg.cfg
PHINTL (language translation) pi1400cc.bin
Over-The-Air Downloader (OTADL) pd14odcc.bin
OTADL Shim pd14shim.bin
USB downloader pd14udcc.bin
Functional (telephony protocol) pd14ccc.bin
2. Use the Handset Administration Tool to set up the configuration of each handset to
meet all essential requirements. If not using the HAT, ensure the following parameters
are correctly set in the Admin menu for each handset: See
Avaya 3641/3645 Wireless IP Telephone Configuration for detailed configuration
instructions.
• If statically assigning IP addresses, ensure that the Phone IP,
Subnet Mask, and
Default Gateway information are accurate. If using a DHCP Server, ensure that
the DHCP option is set.
• Ensure the handset has properly configured SSID and Reg
Domain information.
• Ensure the Telephony Protocol menu option is set to 33. This ensures the
handset will check for the proper files each time it powers on.
• Configure handset security settings to match AP configuration and RADIUS server
settings. If WPA2-Enterprise security is used, credentials will need to be installed
onto the handset. For EAP-FAST, the PAC file needs to be provisioned and for
PEAP the handset will need to be enrolled with a certificate (requires use of the
HAT). See the WPA2 Enterprise PEAP Certificate Enrollment and EAP-FAST
Manual PAC Provisioning section in this guide for details.
3. Configure QoS mode to match the AP and site QoS plan. Follow the VIEW
Configuration Guide for the appropriate make/model of WLAN.
4. Power-cycle the Wireless IP Telephone.
5. The code will now download to the handset. The status bar will increment fully across
the display for each function that is being performed in the download process and the
filename will display. Upon completion of the update process, the handset will re-boot
with the new firmware.
13
Always use the slnk_cfg.cfg file that is provided with the current release. Although the filename does not change from
release to release, the file is release-specific and using a .cfg file that came with an earlier release may cause improper
handset function.
To Next Page
Loading...
