2. AVPP Installation and Configuration
3600 Series IP Phone Installation Page 21
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
2.2 Connecting to the AVPP
The initial connection to the AVPP must be made via a serial connection to establish the AVPP’s IP
address. After the IP address is established, connection to the AVPP can be done via the network using
Telnet. It is recommended that the basic setup actions occur while the serial connection is made.
Connecting via the Serial Port
This method is required for initial access to the AVPP. Once it has been configured with an IP address
future access can be done via Telnet (see below).
1. Using a DB-9 female, null-modem cable, connect the AVPP to the serial port of a terminal or PC.
2. Run a terminal emulation program (such as HyperTerminal™) or use a VT-100 terminal with the
following configuration:
• Bits per second: 9600
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: None
3. To display the AVPP login screen, press Enter.
4. Enter the default login: admin and default password: admin. These are case sensitive. The
NetLink SVP-II System menu is displayed.
Connecting via Telnet
Telnet can only be used after the AVPP’s IP address is configured. Telnet access can be disabled if
required through the Network Configuration menu. Many terminal emulation programs support Telnet
connections, alternately a basic Telnet client can be run within Windows
1. Select Start | Run and enter Telnet.
2. Enter open xxx.xxx.xxx.xxx where xxx.xxx.xxx.xxx is the IP address of the AVPP.
3. Enter the login name and password.
4. If accepted, the NetLink SVP-II System menu is displayed.
To Next Page
Loading...
