3. Phone Configuration
3600 Series IP Phone Installation Page 43
IP Office 4.0 15-601082 Issue 05a (22nd May 2007)
3.5 Testing a Wireless Phone
Verify proper registration and operation of each wireless phone by performing the following tests on each
wireless phone in an active wireless area.
1. To power on the wireless phone, press Power On/Start Call. A series of messages are
displayed as the wireless phone acquires the system. The wireless phone should display the user
extension. Any error messages should clear.
2. Press Power On/Start Call. The extension number should be replaced by information from the
IP Office unit and you should hear a dial tone. Place a call and listen to the audio quality. To end
the call, press Power Off/End Call.
3. Place a call to the wireless phone and verify ring, answer, clear transmit and clear receive audio.
4. Press Power On/Start Call.
5. Press Power Off/End Call. Any line indicators should turn off and the extension number display
will return.
6. Register any further phones.
7. If necessary the IP Office configuration can be altered as required for the user setup, for example
user names and button programming.
8. When completed, proceed to 4.1 Site Certification before handing over any phones to the users.
To Next Page
Loading...
