Avaya 3641/3645 IP Wireless Handset SIP User Guide June 2012 61
Chapter 8: Charger Options
Three charger models are available for the Avaya 3641/3645 IP Wireless Handset. The Single
Charger will charge a single handset with an installed Battery Pack. The Dual Charger will
charge the handset and a spare Battery Pack. The Quad Charger can charge up to four Battery
Packs at a time. Any Avaya Battery Pack can be charged in any of these chargers.
The Single and Dual Chargers allow the handset to remain operative in speakerphone mode or
with a headset while charging. Handsets may be charged while in standby mode, while in an
active call, or while turned off.
Install the Charger
Set up the Charger by first obtaining the appropriate Avaya power supply for the country
or region. Place the Charger on a flat, horizontal surface. Plug the power supply into the
Charger and into an appropriate wall outlet.
Charging Status Indicators
The handset speaker, handset display, and the charger LED (on the Dual and Quad
Chargers), indicate charging status or that a Battery Pack failure has been detected.
Occurs when handset has been inserted into the charger and
charging has begun.
The Battery Pack is charging.
Note that in the Dual Charger, the handset‘s Battery Pack takes
charging precedence. When it is finished charging, the single
Battery Pack in the rear slot will charge.
The Battery Pack in the handset has finished charging.
Battery Pack is fully charged, slot is empty, or unit is not powered.
Battery Failure
LED Flash
Error. Battery Pack not able to be charged. Reinsert Battery Pack
or replace Battery Pack.
Occurs when handset is removed from charger.
To Next Page
Loading...
