• Security cord
• Headset with microphone on boom
• Headset with microphone on cable
DC3 Desktop Charger and DP1 Desktop Programmer
Figure 1: Chargers
You can use any of the following chargers:
• DC3 Desktop charger: Charges the handset only. The charger is delivered with a plug-in power
supply and connected to an ordinary wall socket.
• DP1 Desktop Programmer: Downloads new software and synchronizes parameters. The
handset becomes fully operational when you keep it in a charger.
Note:
Use the charger within the temperature range of +5° C – +40° C.
CR3 Charging Rack
The CR3 Charging Rack is used for:
• Charging several handsets
• Synchronizing parameters
• Downloading software
373x Accessories
Belt Clips
The two belt clip options are:
• Hinge-type clip: The clip on the back of the handset is used to fasten the handset to a belt or
similar. The clip can also be changed to a swivel-type.
Avaya 3730 DECT handset overview
July 2017 Using Avaya 3730 DECT handsets connected to Avaya Integral Enterprise Software
IEE 7.2 14
Comments on this document? infodev@avaya.com
To Next Page
Loading...
