In standby mode, and number input mode
• A short press on a key enter the digits 0 - 9 and the characters * and #.
• A long press on the 0 key adds a "+" to the number.
• Enter a pause in number input mode by a long press on the # -key. A pause is indicated by a P
in the display.
• A long press on the * - key changes the tone sender on. Tone sender on is indicated by a T in
the display.
In text input mode
• A short press on a key 0-9, displays the first available character on that specific key. The
marked character is selected after a timeout, or when another key is pressed.
• To change to upper or lower case, press the * -key before entering the character. The * -key
can also be used to display only the digits.
• To add space in the text, make a short press on key 0.
• The first character entered in a message, or when adding or editing a name in the Contacts
menu, is an upper level character. This upper level character is followed by lower level
characters, unless the * -key is pressed before entering the character. To switch between Abc,
ABC, abc, and 123 the * -key is pressed.
• A long press on the # -key displays special characters.
• A long press on the * -key opens a menu to change writing language. (Default follows the menu
language setting).
Avaya 3730 DECT handset overview
July 2017 Using Avaya 3730 DECT handsets connected to Avaya Integral Enterprise Software
IEE 7.2 20
Comments on this document? infodev@avaya.com
To Next Page
Loading...
