Chapter 5: Menu operation
Managing incoming calls
Incoming call
The flashing LED, accompanied by a ring signal and / or a vibrating handset, gives a notice of a call.
You can disable a ring signal and a vibrator. The handset number or name of the calling party is
shown. The name is shown if the handset number of the calling party is stored in the local phone
book.
Answering a call
Procedure
Do one of the following:
•
Press the Off-hook (
) key.
•
Press
to answer the call using the speakerphone.
• Press the headset button to answer the call using the headset.
The name or number of the calling party is displayed if calling line information is available.
Note:
• When you enable Automatically, all incoming calls are connected automatically.
• If you decline the call, you can still acknowledge its receipt by sending a predefined text
message to the caller.
Ending a call
Procedure
During a call, press the On-hook key.
The handset ends the current call and resumes the previous call.
July 2017 Using Avaya 3730 DECT handsets connected to Avaya Integral Enterprise Software
IEE 7.2 29
Comments on this document? infodev@avaya.com
To Next Page
Loading...
