Chapter 5: Menu operation
Managing incoming calls
Incoming call
The flashing LED, accompanied by a ring signal and / or a vibrating handset, gives a notice of a call.
You can disable a ring signal and a vibrator. The handset number or name of the calling party is
shown. The name is shown if the handset number of the calling party is stored in the local phone
book.
Answering a call
Procedure
Do one of the following:
•
Press the Off-hook (
) or the Accept soft key.
•
Press to answer the call using the speakerphone.
• Press the headset button to answer the call using the headset.
The name or number of the calling party is displayed if calling line information is available.
Note:
• When you enable Automatically, all incoming calls are connected automatically.
• If you decline the call, you can still acknowledge its receipt by sending a predefined text
message to the caller.
Ending a call
Before you begin
A new call has been started during a conversation.
July 2017 Using 3730 DECT Handsets with Communication Manager and IP Office 31
Comments on this document? infodev@avaya.com
To Next Page
Loading...
