Avaya 9600 Series - Holding a Call; Taking a Call Off Hold; Switching Between Calls

Parameter name Default value Description and value range
NVIKECONFIGMODE 1 Enables IKE configuration mode. 1
ASCII numeric digit. Valid values
are:
• 1 = The ISAKMP configuration
method will be supported for
setting the following values:
-
IPADD will be set from a
received value of
INTERNAL_IP4_ADDRESS,
- the IPADD lease time will be
set from a received value of
INTERNAL_ADDRESS_EXPI
RY,
- DNSSRVR will be set from
received value(s) of
INTERNAL_IP4_DNS,
- DHCPSRVR will be set from
received value(s) of
INTERNAL_IP4_DHCP, and
- NVIPSECSUBNET will be set
from received value(s) of
INTERNAL_IP4_SUBNET
• 2 = Disable/turn off this setting
because a generic PSK profile is
in effect.
NVIKEDHGRP 2 Specifies the Diffie-Hellman Group
to be used for establishing the IKE
SA. 1 or 2 ASCII numeric digits.
Valid values are:
• 1 = First Oakley Group
• 2 = Second Oakley Group
• 5 = 1536-bit MODP Group
• 14 = 2048-bit MODP Group
• 15 = 3072-bit MODP Group
For more information, see Section
4 in RFC 3526.
NVIKEID "VPNPHONE" Specifies the identity to be used
during IKE Phase 1 negotiation
(also called the group name in
XAUTH). 0 to 30 ASCII
characters.
Table continues…
VPN parameters
March 2015 VPN Setup Guide for 9600 Series IP Telephones 51
Comments? infodev@avaya.com