Avaya 9600 Series - Transferring a Held Call

Parameter name Default value Description and value range
NVIKEIDTYPE 3 Specifies the type of identification
to use for establishing the IKE SA.
1 or 2 ASCII numeric digits. Valid
values are:
• 1 = ID_IPV4_ADDR
•
2 = ID_FQDN
• 3 = ID_USER_FQDN
• 9 = ID_DER_ASN1_DN
• 11= ID_KEY_ID
NVIKEOVERTCP 0 Specifies whether and when to
use TCP as a transport protocol
for IKE. 1 ASCII numeric digit.
Valid values are:
• 0 = Never use TCP as a
transport protocol for IKE.
•
1 = Auto; use IKE over UDP
first, and if that isn’t valid use
IKE over TCP.
• 2 = Always use TCP as the
transport protocol for IKE.
NVIKEP1AUTHALG 0 Specifies the authentication
algorithm to use during IKE Phase
1 negotiation. 1 ASCII numeric
digit. Valid values are:
• 0 = Any
• 1 = MD5 (per RFC 2403)
• 2 = SHA (per RFC 2404)
NVIKEP1ENCALG 0 Specifies the encryption algorithm
to use during IKE Phase 1
negotiation. 1 ASCII numeric digit.
Valid values are:
• 1 = AES-CBC-128 (per RFC
3602)
•
2 = 3DES-CBC (per RFC 2451)
• 3 = DES-CBC (per RFC 2405)
• 4 = AES-CBC-192 (per RFC
3602)
• 5 = AES-CBC-256 (per RFC
3602)
Table continues…
VPN parameters
52 VPN Setup Guide for 9600 Series IP Telephones March 2015
Comments? infodev@avaya.com