Parameter name Default value Description and value range
will use a source port of 2070,
and the source and destination
port numbers will not be
subsequently changed. UDP
encapsulation of the "inner" IP
layer will be supported as
specified in RFC 3948 [7.3-41c],
using the same UDP source and
destination port numbers that
were used during the final phase
of IKE
• 4 = Procedures for the
negotiation of NAT traversal will
be supported as specified in
IETF RFC 3947. UDP
encapsulation of the "inner" IP
layer will be supported as
specified in RFC 3948 [7.3-41c],
using the same UDP source and
destination port numbers that
were used during the final phase
of IKE
NVVPNMODE 0 Specifies whether VPN is
supported. 1 ASCII numeric digit.
Valid values are:
• 0 = VPN is not supported.
•
1 = VPN is supported.
See DHCPACK Messages for
additional information.
NVVPNPSWD " " (Null) User password for VPN. If the
user password can be stored in
NV memory (see
NVVPNPSWDTYPE below), it is
stored as the value of
NVVPNPSWD. 0 to 30 ASCII
characters.
NVVPNPSWDTYPE 1 Specifies whether and how the
VPN user password will be stored.
1 ASCII numeric digit. Valid values
are:
• 1 = Password can be
alphanumeric and is stored in
reprogrammable non-volatile
memory as the NVVPNPSWD
value.
Table continues…
VPN parameters
56 VPN Setup Guide for 9600 Series IP Telephones March 2015
Comments? infodev@avaya.com
To Next Page
Loading...
