Parameter name Default value Description
VLANTEST 60 Specifies the number of seconds that the phone
waits prior to failing back to a different VLAN ID if
no response is received from the DHCP server.
Valid values are from 0 to 999.
The option is:
• 0: The phone continues to attempt a DHCP
REQUEST forever.
VLANTEST is configured through:
• 46xxsettings.txt file
• A name equal to the value pair in the
DHCPACK message
VLANSEP 1 Specifies whether VLAN separation is enabled
by the built-in Ethernet switch while the phone
tags frames with a non-zero VLAN ID.
The options are:
• 0: Disabled
• 1: Enabled if L2Q, L2QVLAN, and PHY2VLAN
are set appropriately
VLANSEP is configured through the
46xxsettings.txt file.
VLANSEPMODE 1 Specifies whether full VLAN separation is
enabled by the built-in Ethernet switch while the
phone tags frames with a non-zero VLAN ID.
The options are:
• 0: Disabled
• 1: Enabled
PHY2PRIO is not supported when
VLANSEPMODE is 1.
VLANSEPMODE is configured through the
46xxsettings.txt file.
Table continues…
Phone administration
January 2020 Installing and Administering Avaya 9601/9608/9611G/9621G/9641G/9641GS IP
Deskphones SIP 66
Comments on this document? infodev@avaya.com
To Next Page
Loading...
