Independent alerting for each bridged call appearance
You can configure a unique alerting option for each bridged call appearance on your phone if the
administrator has enabled the Independent alerting feature for your extension.
The following four options are available:
• On: The phone plays a ringtone on an incoming call on the bridged appearance.
• Off: The phone does not play an alert ringtone on an incoming call on the bridged
appearance.
• Delayed: The phone plays an alerting melody after a delay if you do not answer a call on the
bridged appearance. Your administrator can configure the delay.
• Abbreviated: The phone plays a single beep to indicate a call on the bridged appearance.
Note:
For multiple call appearance alerting, the phone highlights the call appearance with the most
recent incoming call.
Handling calls and conferences using Multiple Device Access
About this task
With the Avaya Aura
®
and Multiple Device Access feature, you can have up to ten devices
configured with the same extension number. You can use this extension number to transfer active
calls between your devices.
Before you begin
Ensure that the system administrator has activated the Multiple Device Access feature (MDA) for
your extension.
Procedure
1. Initiate a call from your phone.
2. To transfer the call to another phone, press Bridge on your phone.
If the MDA phone that is joining the call uses a different signaling mode address family, you
might notice the Limited Service icon appear on your device for a brief moment. After the
MDA phone that is joining the call switches to using the signaling mode address family of
the active call, the icon disappears.
Sending an active call to voicemail
Before you begin
The feature is available only if the administrator enables the option for your extension.
Handling mid-call operations
October 2019 Using Avaya 9601 IP Deskphone SIP 35
Comments on this document? infodev@avaya.com
To Next Page
Loading...
