Idle timer configuration
When the idle timer in the deskphone expires, you can administer the deskphone to turn the
backlight to the lowest power level, put up a screen saver, or show a Web page while the
deskphone is idle. However, do not set all these values on the same deskphone. However, you
can set a lobby phone to go to a Web page when the phone is idle. You can also set a desk phone
to go to the screen saver or set the backlight to low power mode when idle.
The related system parameters and their default values are:
System parameter Default value
WMLIDLETIME 10 minutes
WMLIDLEURI Null
BAKLIGHTOFF 120 minutes
SCREENSAVERON 240 minutes
You must specify WMLIDLEURI only for phones installed in public areas through the use of a
GROUP parameter.
Table 19: Idle Timer Settings and Results
Shortest Timer Middle Timer Longest Timer Operation
WMLIDLETIME and
WMLIDLEURI are
null
BAKLIGHTOFF is
non-zero
SCREENSAVERON
is non-zero
Default operation:
After BAKLIGHTOFF minutes, the
backlight is set to low power mode.
After (SCREENSAVERON –
BAKLIGHTOFF) additional minutes,
the screen saver is displayed.
WMLIDLETIME has no effect.
WMLIDLETIME and
WMLIDLEURI are
null
SCREENSAVERON
is non-zero
BAKLIGHTOFF is
non-zero
After SCREENSAVERON minutes,
the phone displays the screen saver.
After (BAKLIGHTOFF-
SCREENSAVERON) additional
minutes, the backlight is set to low
power mode.
WMLIDLETIME and
WMLIDLEURI are
non-null
BAKLIGHTOFF is
non-zero
SCREENSAVERON
is non-zero
Every WMLIDLETIME minutes, a
GET is sent for WMLIDLEURI, and
the the phone displays a browser.
The Web page may contain a timer
to cycle through additional Web
pages.
The backlight is set to low power
mode after the specified time and
Table continues…
Administering Applications and Options
March 2018 Administering Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.
323 155
Comments on this document? infodev@avaya.com
To Next Page
Loading...
