Avaya 9600 Series

To Next Page

To Previous Page

Parameter Description

PHY2STAT Controls the secondary Ethernet interface speed. The default is 1 which indicates

that it is auto-negotiate.

PROCPSWD Security string used to access local procedures. The default is 27238 (CRAFT).

PROCSTAT Controls whether local Craft procedures are allowed. The default is 0 which

indicates that access to all administrative options is allowed.

REREGISTER The number of minutes the phone waits before and between re-registration

attempts.

REUSETIME The n umber of seconds to wait for successful completion of DHCP before reusing

previous parameters on the default (port) VLAN. The default is 60.

SIG The signaling protocol download flag that indicates which protocol applies (H.323

(1), SIP, (2) or Default (0). For software releases prior to 6.0, SIG can only be set

manually on the deskphone and not through DHCP or in the 46xxsettings.txt file.

Default means the default protocol supported at that location. A custom upgrade

file is required to support both protocols. For software releases 6.0 and later,

separate upgrade files with different names are used for H.323 and SIP, and

Default means to download the upgrade file for the same protocol that is

supported by the software that the deskphone is currently using.

SNMPADD Allowable source IP addresses for SNMP queries. The default is “ ” (Null).

SNMPSTRING SNMP community name string. The default is “ ” (Null).

STATIC Controls whether to use a manually-programmed file server or CM IP address

instead of those received through DHCP or a settings file. If a manually

programmed file server IP address is to be used, STATIC must be set through

DHCP.

TLSDIR Specifies the path name prepended to all file names used in HTTPS GET

operations during startup.

TLSPORT Specifies the TCP port number for HTTPS file downloading.

TLSSRVR Specifies the IP addresses or DNS names of Avaya file servers to download

configuration files.

Specifies that Transport Layer Security is used to authenticate the server.

UNNAMEDSTAT Specifies whether the deskphone will attempt unnamed registration.

VLANTEST Controls the length of time the deskphone tries DHCP with a non-zero VLAN ID.

When the interval is exceeded, the deskphone records the VLAN ID so that the

VLAN ID is not used again, and DHCP continues on the default VLAN. The default

is 60 seconds.

These parameters are saved in the non-volatile memory of the 9600 Series IP Deskphones. If the

DHCP server is not available for any reason during phone restart or reboot, the phone uses these

saved parameters.

Avaya 9600 Series - Page 57