Parameter name Default value Description and value range
SLMCTRL 0 Specifies whether the SLA Monitor agent supports device
control.
Assign one of the following values.
• 0: Device control is disabled.
• 1: Device control is enabled.
• 2: Device control is disabled. The feature is enabled
from the CRAFT menu.
SLMPERF 0 Valid values are 0 or 1
Specifies whether the SLA Monitor agent supports
performance monitoring.
SLMPORT 50011 Valid values are 6000 - 65535
Specifies the UDP port used to receive commands from
the SLA Monitor server.
SLMSRVR 0.0.0.0:0 Valid values, any
Specifies the source IP address and, optionally, the
source port number of valid discovery messages from an
SLA Monitor server.
SLMSTAT 0 0 or 1
Specifies whether the SLA Monitor agent will be enabled.
SSH_ALLOWED 2 Secure Shell (SSH) Protocol permission flag. (0=SSH is
not supported, 1= SSH is supported). “Supporting SSH”
means the Avaya Services organization can have remote
access to the deskphone, using SSHv2, as described in
topic Secure Shell Support.
When value =2, SSH will still be disabled by default (i.e.,
the SSH server listen port will be closed), but SSH will be
able to be manually enabled (or disabled if it was
previously manually enabled) from the Craft Debug
procedure.
SSH_BANNER_FILE “ ” (Null) Specifies the file name or URL for a custom SSH banner
file. Zero to 255 ASCII characters: zero or one file name
or URL. Used to provide a security warning message to
the client before SSH authentication is attempted.
If the parameters is left at the default value, the default
banner message is as stated in the topic Secure Shell
Support.
SSH_IDLE_TIMEOUT 10 Specifies the number of minutes of inactivity after which
SSH will be disabled. Valid values are 1 to 5 ASCII
numeric digits, zero through 32767.
Table continues…
Administering Deskphone Options
March 2018 Administering Avaya 9608/9608G/9611G/9621G/9641G/9641GS IP Deskphones H.
323 97
Comments on this document? infodev@avaya.com
To Next Page
Loading...
