Avaya 9601 - Page 48

Local administrative options
48 SIP Deskphones Release 6.4 Installation and Maintenance Guide
● dddd is the current value of L2QVLAN and ddd is the current value of VLANTEST,
respectively.
● AVohhhhhh where o has one of the following values based on the OID (first three
octets) of the deskphone's MAC address:
- "A" if the OID is 00-04-0D,
- "B" if the OID is 00-1B-4F,
- "E" if the OID is 00-09-6E,
- "L" if the OID is 00-60-1D,
- "T" if the OID is 00-07-3B, and
- "X" if the OID is anything else, and
where hhhhhh are ASCII characters for the hexadecimal representation of the last three
octets of the deskphone's MAC address
3. Use the navigation arrows to scroll to and highlight the address/item you want to change,
then use the appropriate softkey(s) and the dialpad to change the value as described in
Step 3.
4. Depending on the item you selected, choose one of the following:
If you want to Then
Change any of the IP
Address values (File,
Phone, Router,
Subnet Mask, &/or
DNS Server)
Use the dialpad to enter the new IP Address. IP Addresses have
four sets of three digits followed by a period. Pressing * following
entry of three digits causes a period to be placed in the next
position, and the cursor to advance one position to the right.
For example, to enter the IP Address 111.222.333.444, press the
1 on the dialpad three times then press *, press the 2 on the
dialpad three times then press *, press the 3 on the dialpad three
times then press *, then press the 4 on the dialpad three times.
Proceed to the next step.
Change the VLAN ID
value
Use the dialpad to enter the new static VLAN ID of from 0 to
4094, inclusive. Proceed to the next step.
Change the
VLANTEST value
Use the dialpad to enter the new value of the DHCPOFFER wait
period of from 0 to 999, inclusive. Proceed to the next step.
Ping a server (host) to
see if it is reachable/
available
Use the dialpad to enter the IP Address or the DNS Name of the
server you want to check. IP Addresses have four sets of three
digits followed by a period. Pressing * following entry of three
digits causes a period to be placed in the next position, and the
cursor to advance one position to the right.
Press the Ping softkey to initiate the check. The deskphone
sends four pings and displays the results in a text block screen. If
the ping fails, the message "Unable to contact host" displays.